Designed to be used with copper compression, one-hole lugs
After being crimped onto the cables the lugs are bolted together in a pigtail configuration, then insulated and sealed with the 3M motor lead splicing kit
Makes three splices and contains the necessary materials (except lugs) needed to make three splices
Accommodate the following splice configurations- 1000 Volt and less Pigtails (stub) connections, 1000 Volts and less inline connections, 5/8 Kilo-Volt shielded and non-shielded feeders pigtail (stub) connections, 5/8 Kilo-Volt shielded and non-shielded feeders inline connections
Fast and simple installation
No torches or heat source required
No special tools required to install splice
Single conductor cable
Detailed Description: 3M Motor lead pigtail splicing kit includes instruction sheet, three lug covers, three mastic sealing strips and three tubes of silicone grease. Kit is ideal for splicing 12 - 4 AWG sizes motor lead cable wire to incoming 10 - 4 AWG sizes feeder cable wire, including the accommodation of pigtails connections at 0 - 1000 Volts. Kit makes three splices. It has the abrasion and puncture resistant properties. Lug cover is made using EPDM rubber as a slip-on. Moisture seal is done using mastic. Maximum bolt length is 1/2-Inch and lung cover inner diameter is 0.70-Inch. UL listed copper lugs and Scotchlok ™ 30000 Series copper compression lugs can be used with kit. Kit is CSA certified.
Application | motor lead 12-14 AWG |
Brand | 3M |
Catalog Description | 3MÖ Motor Lead Pigtail Splicing Kits 5300 Series are designed for splicing motor lead cables to incoming feeder cables, including the accommodation of pigtail (stub) connections at 1000 volts and less. The spliceÆs main component, the slip-on lug cover, is made from EPDM rubber. Mastic strips are used for the moisture seal.These kits are designed to be used with copper compression, one-hole lugs. After being crimped onto the cables, the lugs are bolted together in a pigtail configuration, then insulated and sealed with the 3M Motor Lead Splicing Kit. Each kit makes three splices and contains the necessary materials (except lugs) needed to make three splices. The lugs must be purchased separately. 3MÖ ScotchlokÖ Copper Compression Lugs 30000 Series, or other UL listed copper lugs, can be used.Kit contents include:ò (3) Pigtail lug coversò (3) Mastic sealing stripsò (3) Locking pins (kits 5302û5304 only)ò (3) Tubes of silicone greaseò (1) Instruction sheet |
GTIN |
00054007122630 |
Height | 3.4000 |
Height Unit | IN |
Item Status | A |
Length | 7.9000 |
Length UOM | IN |
Mfr. # | 5301 |
Type | Pigtail |
UNSPSC | 39121718 |
Width | 6.0000 |
Width UOM | IN |